Trapshooters Forum banner
Status
Not open for further replies.
1 - 11 of 11 Posts

·
Registered
Joined
·
73 Posts
Discussion Starter · #1 ·
1. MEC 600 JR. 20 gauge complete with 3" conversion. $85.00 shipped in lower 48

2. MEC Sizemaster 12 gauge currently set up to load 3". This loader is complete but does need a good cleaning. $100 shipped in the lower 48

If you PM me a cell phone number I will send pics on that.

Thanks
 

·
Registered
Joined
·
980 Posts
I have an old (70's) MEC 650 that is missing a flat triangular part that rests on the top of the plate that attaches to the crimp die below it. It also serves as an operating rod guide on the downstroke.

I suppose I could make the damn thing but wouldn't mind taking the lazy way out if anybody knows where I can find one. MEC doesn't make them anymore.

Regards,

Bill
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top