Trapshooters Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Does anyone have a spare stock for a 3200 they're interested in selling ? I'm looking for a winter project piece so any condition will do, providing it's solid.
 

·
Registered
Joined
·
56 Posts
I have just what you need; ha; that is a unfinished, unfitted, one of those 95% completed--I seem to remember paying $35, so I will take $45,

I also have another one that is finished--$75

AND I also have a complete set from a competetion model,
excellant figure ( didn't fit me)as new also. $295

Give me a shout if interested and I shall hunt them up to verify my memory.
 

·
Registered
Joined
·
56 Posts
Bob: are you asking about the 95% stock?
Incidentally, upon checking thru my pile I also found a unfinished forearm.
Therefore I have a complete set of 95% wood!!!
This would appear to get you started on a project,
not sure where I got them, they are solid pieces.
Interested? Give me a line!

Warren J Roberts
 

·
Registered
Joined
·
70 Posts
Sounds good Yes I'am interested. What is required to fit the 95% stock and forearm to a gun. Does the finished stock have a forearm and what is required to fit it to a gun? Do you have any pictures? Bob.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top