Trapshooters Forum banner
Status
Not open for further replies.
1 - 11 of 11 Posts

·
Registered
Joined
·
5,696 Posts
Discussion Starter · #1 ·
I'm looking to buy O/U barrels 29.5' or 31.5" that will fit a 70's Ithaca import Mirage skeet gun.
 

·
Premium Member
Joined
·
10,462 Posts
I have a set of very tight- CAT 4 P barrels- one barrel fixed choke and one factory P choke tube

ported

locks up like new

$1777

regards from Iowa

Gene
 

·
Registered
Joined
·
8,065 Posts
Most likely it's type 3, but,

Check the back side of your forend iron, if they look like these, they're type 4, if it doesn't have the two screw holes, it's type 3.

<a href="http://photobucket.com" target="_blank">
</a>

Also, ser. # over 51243 is type 4. but that can be modified or updated, so, the screw holes are the sure way.
 

·
Registered
Joined
·
2,984 Posts
I've got a set of O/U bbls 31.5 " for a old Comp.I . They are choked with Briley chokes. Show considerable wear, but work perfectly. Price would be $1000.00

puablo
 

·
Registered
Joined
·
100 Posts
Glen please e-mail the spec's Length,any aftermarket work ect and pic's if you have them thanks Charlie (drop the xx's on e-mail address)
 

·
Registered
Joined
·
5,696 Posts
Discussion Starter · #10 ·
It looks like my gun is a Category 3. It is a Mirage skeet imported by Ithaca in the early 70's. The barrels I have now are the original ported skeet barrels with Briley Thin-wall chokes.
 
1 - 11 of 11 Posts
Status
Not open for further replies.
Top