Trapshooters Forum banner

1 - 13 of 13 Posts

·
Registered
Joined
·
507 Posts
Discussion Starter #1
Need powder bushing #477. Can't find one anywhere. Anyone got one they don't need or know where one is???

Paul
 

·
Registered
Joined
·
12,397 Posts
Make your own, buy a .477 drill bit and drill out a smaller bushing.

Better just fine a machine shop that has one, they cost at ACE $14 or more for the bit.

Been there, done that.

Good luck
 

·
Registered
Joined
·
507 Posts
Discussion Starter #9
Tom....I did my best to hide this thread from you!!!! How the hell have you been? Hope you are shooting well....

Paul
 

·
Registered
Joined
·
507 Posts
Discussion Starter #10
No one makes a 477??? But they make a 471, 474, 480, 483, etc. Guess I gotta ask...why no 477????

Paul
 

·
Registered
Joined
·
3,280 Posts
According to my Lyman number 3, they used to make a 477 bushing. It was used for the old Alcan powders in the 366.

Ajax

I did go look in my bushing and do not have one of that number but as said below, it's not hard to take a smaller one out to that size.
 

·
Registered
Joined
·
507 Posts
Discussion Starter #13
Well...in a previous life I DID try the old "open up a smaller one" solution. In the immortal words of Clint Eastwood...."A man's GOT to know his limitations".

I have learned that at one time these were made...so, still looking.

Paul
 
1 - 13 of 13 Posts
Top