Trapshooters Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1,596 Posts
Discussion Starter #1
I know this is a long shot. I bought a 5100 for a project gun. It has 24" barrels that must have been cut down. I plan to cut them down to 18.1" or so. But, the gun is ok for such an old thing. I'd like to get some original barrels for it, to preserve it and shoot it at an occasional SxS event, or once in a while for trap as a hoot.

Danny
 

·
Registered
Joined
·
3,852 Posts
I have a set of 30" Mod/Full from a 311 Savage Ejector model.. You'll need to either add the ejector parts.. or just change it to extractor.. I'd take $200 for the barrels.. It's in very good condition.. original bluing 92% ++
 

·
Registered
Joined
·
331 Posts
If you are not interested in PerazziBigBores deal I have a set of old 5100 barrels they are 30 inch complete with extractor and cocking rod.It has the two hole drilled rib for center bead but the ivory sights are broke off.I replaced the forwaed bead with brass bead. They are in very good condition,in my opinion for the age of them. Just let me know if interested.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top