Trapshooters Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
176 Posts
Discussion Starter · #1 ·
Does any one know the weight of the Woodson Ent stock weights? I want a 7/8" diameter weight but how can I figure out the weight per inch? I am thinking of ordering one, but I not sure how long. Also, what are your opinions on the Edwards Recoil reducer? Thanks,
gjmen
 

·
Registered
Joined
·
1,903 Posts
Edwards work well if you have them adjusted just right. For a trouble free no hassles installation try The C&H Mercury recoil reducers. I do sell either one in my shop and website.
Don
 

·
Registered
Joined
·
176 Posts
Discussion Starter · #3 ·
I tried one of these mercury type reducers once in a friends gun, I didnt like the sloshing sound I heard coming from the stock. gjmen
 

·
Registered
Joined
·
2,512 Posts
gjmen,

I can configure any solid weight you want. I make all weights out of 1018 Cold Roll Steel. If you want one that is 7/8" diameter, I can make length to match weight. I also make them rust resistant. Please contact me.

Matt Woodson - Woodson Enterprises
Phone: (270) 804-5454
 

·
Registered
Joined
·
1,398 Posts
to figure the weight of round steel use this formula:

dia. x dia. x 2.67 / 12 = lbs per inch.

then multiply by the length, (for 2 1/2 inches use 2.500)



.875 x .875 x 2.67 = 2.0442187 / 12 = .1703515 x 2.500 = .4258787 lbs

for a piece 7/8 dia by 2.500 inches long.

for brass use 2.9 in place of the 2.67.



hope this helps.


tony
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top