[wahtsamoie]

Looking for a barrel that has a non- messed with choke, or ported milled rib (2-pin) barrel. Will consider complete front end or just barrel with receiver extension. Bluing not a concern, no pits. I would consider whole gun if the receiver is worn out and recoil notch hammered , out of time, headspace issues etc. I have a good two pin gun that has a Cutts on it, would consider a trade if someone wants to get rid of a trap gun and could use a skeet gun.

 

[Knick nak]

You have a PM

 

[brdslayr]

Here ya go. 30 in 2 pin vent rib. Correct MOD choke. Perfect bore. Oh yeah, and it's Stainless Steel factory Winchester. $1800

 

[wahtsamoie]

That is a cool barrel. What happened to the Japaned varnish? What I am doing is building both of my grandsons a M12 trap gun. I located a brand new 2-pin barrel and bought it. It is also modified choke. I am having them both engraved. Thanks for replying this just won't work for my project. Regards.

 

[brdslayr]

I could use a back half w/o barrel assembly if you get in that situation. Then I would use this unicorn.

 

[wahtsamoie]

I could use a back half w/o barrel assembly if you get in that situation. Then I would use this unicorn.

There was a really nice one complete (1959 gun) sold on here just a few days ago. I think it was less than $200.00 it lasted about as long as a snowball in hell. It is all in timing! Thanks for replying.

 

[checker]

PM sent
I'll take the barrel