Trapshooters Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
242 Posts
Discussion Starter #1
Send me your EMAIL and I can forward you the PDF on Winchester Long Guns Most models covered all take down diagrams.
Mark
 

·
Registered
Joined
·
4,993 Posts
Found on shotgunworld.com


To insure proper fit of the forearm between the receiver face and the mag tube bracket(ring on bbl), forend spacers are furnished with new forearms.

Spacer no.1 (complete circle) grips into place and spacer no.2 and no.3 (horseshoes) are then added to minimize the looseness encountered when the forearm is assembled and the valve assy(mag tube cap) is tightened in place.

The spacers go on the forearm...magtube cap side. Full ring first, horseshoes after.

More spacers can be added if forearm remains too loose.



Read more: http://www.shotgunworld.com/bbs/viewtopic.php?f=12&t=163546#ixzz1DgZ4KvrV
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top