Trapshooters Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
6,231 Posts
Discussion Starter · #1 ·
These aluminum posts are a little cheesy, plus they're too short (they are 11/16" long and I need 1-1/16"). Before I make my own replacement stainless posts, I was wondering if anybody offers them ready-made.


Fastener



Or, is there a good brand of total replacement comb hardware that replaces this with minimal agony? I'd prefer not to plug the existing holes and start over.

Thanks in advance for information and constructive comments.

-Gary
 

·
Registered
Joined
·
1,258 Posts
Yes they make replacement place called Add-A-Rib if you have access to machinery cheaper to make your own. I made mine from cold rolled steel. The rest of your hardware looks ok. The rings in your comb can be redrilled to a bigger set screw.


Jerry Lewis
 

·
Registered
Joined
·
403 Posts
Add a rib is part of stock positioning systems.com

They have factory OEM replacement comb hardware.

I have their com hardware but my stock was not cut our of the box, also a recoil system and a adjust a rib
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top