Trapshooters Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
12,479 Posts
Discussion Starter #1
Can anyone tell me how to remove the front iron from the wood on a TMX? On my K80 it's pretty easy. Two screws and it's off. I don't see any screws on the TMX. Thanks, Bulge.
 

·
Registered
Joined
·
1,425 Posts
While looking inside the forend, push the release button in until the holes lineup on the iron. It takes a very small screw driver to remove the screw that is in the hole. Pull out the button. Then insert your 5mm stock wrench into the botton hole and undo the locking bolt.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top