Trapshooters Forum banner
Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
328 Posts
Discussion Starter · #1 ·
I see on the diagram that the Forend opening button turns, is this to remove the unit from the forearm or is it used to tighten the forearm to the action?
 

·
Registered
Joined
·
3,723 Posts
It does not tighten the forearm to the action. To remove the forearm wood from the iron you must push the button in until that tiny screw is visible through the hole and then take out the tiny screw and remove the push rod with the button at the end. Sorry about the terminology but I don't have my parts list handy.
 

·
Banned
Joined
·
5,706 Posts
After you remove the pushbutton decribed above use an allen wrench in the hole and tighten or remove as needed


Gary Bryant
Dr.longshot
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top