Trapshooters Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1,473 Posts
Discussion Starter #1
I have a old TM1 that needed a new ejector. No matter what we tried, we could NOT depress the pin and spring to remove the old ejector. Had to have a very good machinist mill the old ejector out in several pieces. What we found was that the spring, $0.50 part, had broken and part was wedged in between the pin and the wall of the pin hole.WOULD NOT MOVE!!!. The cure: go through the hole that you normally would insert the paper clip through and drill all the way till comes out other side. Thread this hole and insert a bolt till it almost touches the ejector, Cut the bolt head off flush and notch it so can be removed with a screw driver. No spring to get jammed again ever. I did this to my other TM1 also before it had a chance to happen again. Very cheap fix if you do it before this nightmare happens to you. Perazzi could learn something from this for sure. Believe it cost me $800.00 (friendly price) Consider this simple fix before this happens to you. Gud luk and gud shooting.
 
1 - 1 of 1 Posts
Top