Trapshooters Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1,421 Posts
Discussion Starter #1
I'm looking for information on a Stan Baker unsingle with adjustable rib. How many did he make? Also information on best method of making adjustments.

At the front of the rib there are two allen head screws. One vertical(adjusting screw) and one horizontal(the locking screw) There is another allen head screw on the mid barrel post. I think this one would need to be loosen to allow the adjustment.

Let me know if I'm headed in the right direction to adjusting this rib.

Thank you.
 

·
Registered
Joined
·
1,608 Posts
You are correct about loosening the mid barrel allen head screw to adjust the rib. Loosen mid allen head screw, loosen the horizontal locking screw in the front and use the adjusting screw to move the rib up or down as required. When you have it where you want it tighten the mid allen head screw and the front locking screw.

I don't know how many he made but I suspect most were for the Remington 3200. I have known of some made for Perazzi, Krieghoff and Browning Superposed. Which one do you have?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top