Trapshooters Forum banner

Status
Not open for further replies.
1 - 10 of 10 Posts

·
Registered
Joined
·
95 Posts
Discussion Starter #1
I know I saw that someone was making and selling shell dismanlers on here. Can anyone help me? I have tried searches and can't come up with anything Thanks in advance.

Terry B
 

·
Registered
Joined
·
929 Posts
Would this be the Metal one with the carbide cutter? If so I would like to make connection with the seller. Thanks J.Woolsey
 

·
Registered
Joined
·
1,487 Posts
I use a single edge razor blade and a pair of needle nose plyers. Works well but I wouldn'd want to dismantle 100 this way. For the occasional dud shell, it works well. First, cut the end of the shell off at the crimp (start your cut and roll the shell on a flat surface); pull out the wad slowly, then dump the powder.
 

·
Registered
Joined
·
5 Posts
I use a PVC pipe cutter cut right thru the wad between powder and shot needless to say hulls are toast but you can save everything else.
 

·
Registered
Joined
·
10,458 Posts
Gregg1966- I too used the PVC cutter until I tried Gary's cutter. End of story and end of the PVC cutter
 
1 - 10 of 10 Posts
Status
Not open for further replies.
Top