Trapshooters Forum banner

Shell catcher Remington Model 1100 12 gauge

1141 Views 7 Replies 6 Participants Last post by  Sgoose
Looking for a snap-on type . Thanks for your help.
Sgoose
Status
Not open for further replies.
1 - 8 of 8 Posts

· Registered
Joined
·
3,963 Posts
I've had both. The plastic one is better. The metal one slides around and can scratch the receiver.
My experience was just the opposite. I used a metal TS clip for a long time but finally it gave way. Plastic was the only type available. That thing would jam the bolt and make it almost impossible to clear the action after firing a shot. Finally found a new metal TS and have had no problems. Maybe the rejection port on my, rather old, 1100 is just a bit smaller or maybe the plastic catcher was just a bit oversize but in either case, the plastic one did not work well for me.
 

· Registered
Remington 1100
Joined
·
191 Posts
It seems the metal T& S shell catchers are gone never to return. The plastic ones only need a little sanding off the top edge and the bolt handle clears it with no problem.
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top