Trapshooters Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
3,249 Posts
Discussion Starter · #1 ·
You're talking about on the bottom of the 2 barrel lugs that fill the square holes in the bottom of the receiver? I used an engraver's Arkansas stone to remove those. You can accomplish about the same thing by getting some 1000 grit and some 1500 grit wet/dry sandpaper from an auto paint shop, wrapping it over something flat and hard and using that to remove the scratches. Follow that up with some Flitz and it should look good. Then you have to be more careful when assembling the gun 'cause so you don't eventually polish off the lugs.

MK
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top