Trapshooters Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
2,226 Posts
Discussion Starter #1
Need help I just bought a stock on line and discovered that it had a glue on pad on the comb. Any ideas on how to remove without damaging wood or finish. Thanks in advance. Jim W.
 

·
Registered
Joined
·
2,981 Posts
Have fun!!! I removed one about a month ago. Start by tearing most of it off, the use "GOO-GONE" and "WD-40" to remove the glue.

doug
 

·
Registered
Joined
·
3,932 Posts
Along with Doug's recommendations, I'd also use a hair dryer to warm it up first. This will help to soften the adheasive and make the chore a little easier.

Caution here, Don't use a heat gun unless you have used one a lot. It is very easy to damage the finish if you get it to warm.

ss
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top