Trapshooters Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
269 Posts
Discussion Starter #1
I am seaching for a lower barrel extractor for a Remington 332 12gauge. I've tried several likely places like Brownells, with no success.
This model Remington was only produced for a couple of years (2003-2006).

If you may have one laying around, please email me.

Thanks,

John
252-675-8689
 

·
Registered
Joined
·
13,395 Posts
Ejectors from the Peerless (320) and 396 SHOULD work... All these guns were basically the same except for cosmetic differences.
 

·
Registered
Joined
·
269 Posts
Discussion Starter #3
The gunmith at Brownell's said that the Peerless ejector is close in size but would need to be resized somewhat. I guess this could be a fall-back plan if I can't find the M322 ejector. Peerless parts are tough to find as well but Brownell's thinks they may be able to find one.
Thanks,
John
 

·
Registered
Joined
·
13,395 Posts
Forgot about the 300 Ideal which would fall into the same category as well.

Have you checked with Numrich Arms (e-gunparts.com) or Jack First?
 

·
Supporting Vendor
Joined
·
9,757 Posts
Ian, not to argue, but the Ideal and 332 are almost identical but share almost nothing in common with the Peerless/396 at all. I've owned them, they were way different guns.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top