Trapshooters Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
289 Posts
Discussion Starter #1 (Edited)
image.jpeg image.jpeg image.jpeg image.jpeg image.jpeg image.jpeg image.jpeg Used Custom Ultimate Fit Comb Assembly image.jpeg
$90.00 shipped to the lower 48. Shipping Insurance at buyers cost
Includes. Payment by US Postal Money order.
One set of low posts and hardware
One set of high posts and hardware
Bracket fastners and hardware
3 sets of 1/16" spacers
Wood comb, Brazilian Cherry, stained black walnut, polyurethane finish.
Comb is tapered on the sides as well as on the top, wedge shaped with radiused ends.
Custom bracket, anodized black, 1/4" material.
Bracket is threaded for positioning fastners (8-32). The positioning fastners, if used
Will extend down to the bracket mount. This will allow the assembly to be removed
and reinstalled to the same position.
****The comb and bracket height will more than likely be to tall for a low rib gun. I made this for my K80 Trap Special. Height was good, but I did not like the shape of the comb. The taper on top was to make the comb parallel to the rib. I made another comb and did not wet sand this one. There is enough wood to reshape if you care to.
 
1 - 4 of 4 Posts
Top