Trapshooters Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
97 Posts
Discussion Starter #1
Help w a Beretta Urica Trap Recoil Pad

I bought my grandson a Bretta 391 Urica Trap gun. I want to reduce the size (thickness) of the recoil pad to have the gun fit him better. The current pad is installed by a wire the goes into the pad around projects that hold it to the stock and allow one to install or remove the pad by pulling out the wire.

I bought the thinnest recoil pad that Beretta says fits a Beretta 391 Urica Field gun (the pad says Sporting Skeet). It does not install by the wire but by screws.

Can I install this pad by screws? What size and length of screws do I need?

Any help or suggestions would be greatly appreciated.

Thanks- Terry Sandlin
 

·
Registered
Joined
·
6,154 Posts
I added the Wire clip installed gel pad to a Beretta gun that originally had a screw on pad. I don't remember it being anything tricky. The wire clip engages slots in the special screws that came with the pad kit. It was not a 391 but I believe if you take the special screws out, that a screw on pad with the proper regular screws will screw right on.
 
1 - 3 of 3 Posts
Top