Trapshooters Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter #1
Having problems with the wad guide hitting the top of the shell case when it comes over the top of the case. Using AA casings. Can't see any adjustment for this. Anyone had this problem? What are the updates on these reloaders that people talk about? Will call RSBS on Monday if I can fix this weekend. Any other little tricks from users of the grand. Thanks.
 

·
Registered
Joined
·
127 Posts
Are the "fingers" inside of your wad guide black or white? This was one of the upgrades, and I have not had any problems with the newer white ones. Ask for all of the upgrades when you call and they will send at no charge. You will also eventually need the small plastic pieces that hold the shell in place at each station, and the pin assembly on the right hand side of charge bar. You should be good to go for awhile after that.

Mike
 

·
Registered
Joined
·
237 Posts
you can adjust the wad guide arm...it is a two piece affair. There should be an adjustment on the back of the cast wad guide arm to raise it up. Also check to make sure that the wad seating ram is just forward of center in your hull on the downstroke.. There is a PDF manual on RCBS website if you dont have one. Mike
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top