Trapshooters Forum banner
Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
141 Posts
Discussion Starter · #1 ·
Does any one have any infomation or knowledge on McDaniel release triggers..I have a trigger group for a 1970 TM1. It is marked "R" on the bottom but is a pull..There are mods that must have been for the release conversion..I remember this name during the 60's and 70's.but kid's did not shoot release back then..

Break them all...

Ron
 

·
Registered
Joined
·
8,533 Posts
Question for the

You might try asking Kerry Allor about the McDaniels release.
 

·
Registered
Joined
·
141 Posts
Discussion Starter · #3 ·
Question for the

How would I get in touch with him?? Have out of the sport for 25 years...

Break all of them..

Ron
 

·
Ljutic Nut
Joined
·
2,939 Posts
Question for the

I have a McDaniel double release trigger for my MX-8. I had Phillip do some work on it a few years ago. He knew McDaniel's work inside and out.


Jim R
 

·
Registered
Joined
·
2,120 Posts
Question for the

i have a 1983 MX-3C that i ordered from Italy with 3 trigger groups ,2 release and one pull,they were Mc Daniels,the TM-1 and the TMX were both Mc Daniels releases too
 

·
Registered
Joined
·
3,710 Posts
Question for the

I have a leaf spring McDaniels release for the TMX and it was built from Perazzi parts that were listed on the addendum to the TM1-TMX parts list diagram. I also have a coil spring release for the TMX and it was also made from Perazzi parts. I believe McDaniels assembled the trigger for Perazzi. A Pull trigger would be missing the release hook and sear.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top