Trapshooters Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
367 Posts
Discussion Starter · #1 ·
I have a Percision Fit Stock that I purchased used. I watched a video on how to adjust the spring tension of the recoil and it said to take out the first plug to get to the adjustment plunger... problem was the first plug was never installed and what I took out was the tensioner plunger and all the washers...big mess. Good news is I have all the washers. Does anyone know the pattern on how these washers go back in?
 

· Premium Member
Joined
·
30,370 Posts
I have a Percision Fit Stock that I purchased used. I watched a video on how to adjust the spring tension of the recoil and it said to take out the first plug to get to the adjustment plunger... problem was the first plug was never installed and what I took out was the tensioner plunger and all the washers...big mess. Good news is I have all the washers. Does anyone know the pattern on how these washers go back in?
Sets of 3 ((()))((())))((()))((())) etc.
 
  • Like
Reactions: mpolans

· Premium Member
Joined
·
30,370 Posts
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top