Trapshooters Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
1,630 Posts
Discussion Starter #1
Since I only have an unsingle and broke my bottom spring today, I used the top spring as a temporary replacement, but now the top hammer does not have a spring on it.

1) Is it ok to leave it without a spring since it's never used anyway?

2) What is the best way to keep the top spring-less hammer when using the trigger? Down and back or up and forward?

Thanks
 

·
Registered
Joined
·
3,638 Posts
Is your hammer spring a factory Perazzi spring or a new universal spring made by Marcello ? My older MX-3 has a definite right and left and will not interchange. If I were going to shoot only one barrel, I would remove the cocking foot in the other side but if there is no hammer spring I don't think it matters.
 

·
Registered
Joined
·
1,866 Posts
Argh, and you just sent me your backup!! Call Jim Flynn or Jim White or one of the vendors that can get you springs quickly.
 

·
Registered
Joined
·
839 Posts
Hello Vpr80,
the best way to do the job is what Mike suggests you.
What kind of springs do you have on your trigger?
I don't have you on record but anyway I want to remind that my springs have one year warranty.
 

·
Registered
Joined
·
1,630 Posts
Discussion Starter #5
Hey guys, I actually have the springs with the pin in them so I need one or two of those. I have plenty of the regular springs, but none with the pin holes.

Mine don't have the little tabs on the sides so they look to be interchangeable.

Marcello, email coming your way.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top