Trapshooters Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Banned
Joined
·
9,042 Posts
Discussion Starter #1
Does anyone out there know how to remove the trigger gaurd once you have removed the pin from the trigger assembly. I tried to pull out the rear and rotate the guard but it will not pivot on the front peg. Thanks, Jon
 

·
Vendor
Joined
·
2,160 Posts
Jon,

If you pull the trigger bow slightly out of the recess in the housing and rotate it counterclockwise, it should unscrew.

I know the MX series trigger guards come apart this way.
 

·
Banned
Joined
·
9,042 Posts
Discussion Starter #5
Thanks guys. It was in there real tight. I just did not want to force it without knowing exactly how it was in there. Thanks again, Jon
 

·
Strong Supporter of Trapshooting
Joined
·
4,727 Posts
Not sure it was mentioned, but you will most likely have to remove the pin from the trigger blade so that you can move it up so as not to get scratched as you unscrew the guard.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top