THE FIRST "I WILL TAKE IT GETS THE ITEM" AND THE BUYER NEEDS TO POST "I WILL TAKE IT ON THIS AD"
Fajen stock set for Perazzi TM. Unfortunately I don't have a TM to get measurements from at the moment, but matching up the inlets and laying a MX8 sporting stock over top of it, I'm 99% sure it's for a a TM1 low rib (although it would work for a TMX if you raised the comb). Stock measures 15 7/8" from center of pad to center of inlet with the LOP adjuster in a far as it can go, although you could lose a decent chunk by taking off the Morgan pad.
OEM adjustable comb and length of pull adjuster. Someone added a Morgan Pad with a bit of right hand twist and additional drop at heel. Stock has dual palm swells, and appears to have a slight amount of right hand rollover, but looks to be fairly neutral otherwise. Some nicks and dings on the stock. There is a mark at about 5:45 at the top tang inlet, I looked at it through a loupe and it doesn't look like a crack, it looks like a VERY small spot of the finish lifted. Forend appears to have been refinished with Tru-Oil, and is a bit thin in spots, also appears the barrel channel may have been sanded/opened (I get 1.060" at the chamber end, .940" in the middle and about .900" at the muzzle end). Forend width is a hair over 2 inches.
Would make a great winter refinish project for less than it'd cost to have a comb and LOP adjuster installed on your stock.
And before anyone asks, no, that isn't a left hand adjustable comb. That's the original Fajen hardware design, which was as far as I can tell one of the first if not the first generation of adjustable comb hardware, and is different than modern designs. If the looks don't suit you I've seen people put walnut plugs in and install traditional hardware.
$525 shipped in CONUS. 3 day no-modify inspection, buyer pays shipping both ways if returned.
As with all break action shotgun wood, gunsmith fitting may be required.
