Advice / instruction needed on stock removal for a new Perazzi MX2000 RS . The recoil pad has a top slit in the rubber but I can not seem to feel a phillips or slot type screw inside of it . The bottom of the recoil pad does not have a hole or slit in it. I have tried to insert the long hex stock removal tool in the center hole but I can not seem to be able to align it with the hex screw holding the stock to the receiver.
Is the recoil pad glued on at the factory ? Can the stock be removed without removing the recoil pad ? I know the procedures are in the instruction booklet but I have misplaced it.
Your expert advice is appreciated ,
Thank you ,