Trapshooters Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
491 Posts
Discussion Starter #1
Can any of you Perazzi guys tell me the rib height on a Perazzi TMX?

At the receiver, at the muzzle?

Thanks

Hal
 

·
Registered
Joined
·
3,672 Posts
I just measured the height of my TMX rib at 19 mm receiver and 16 mm muzzle for a 3 mm slope

this equates to .76" and .64"

by comparison my MX3 single barrel rib measures 10 mm @ receiver and 5 mm @ muzzle
for 5 mm slope and this equates to .40" and .20"

So the MX3 has a steeper slope to the rib, The POI is the same for both guns at about 9" high at 40 yards but I see more space between the beads with the TMX.
 

·
Registered
Joined
·
3,672 Posts
Richard, are your numbers the width or height ? I carefully measured from the top of MY RIB to the barrel by marking a business card with a pencil instead of looking at a catalog.
 

·
Registered
Joined
·
823 Posts
Some of the numbers in "the book" were over and above what a flat rib would measure, as in "3.5 mm above a flat rib".
 
1 - 6 of 6 Posts
Top