Yourself, or paying someone? If you're replacing a locking block (with jig, $195), top lever spring ($8), and firing pin springs ($12), about $215, assuming you have some basic tools If you already have a locking block jig, about $140, plus about an hour of your time. Or $325-525 to have Don Rackley do it.
$500 should cover most of the work required. I had a locking block, springs and a good look over for problems done by Dan from Giacomo and I think the bill was around $425 for my MX8 Mirage. Should be good for thousands more rounds.
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.