Trapshooters Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
774 Posts
Discussion Starter #1
I am looking at a nickeled MX2005 receiver and am wondering if it is machine or hand engraved. On the bottom right side of the receiver where the trigger goes in, the name Gerri or Terri is engraved. Thanks in advance.

Dave Eberhart
 

·
Registered
Joined
·
835 Posts
I've got a factory SC3 MX2000/10 with what looks like "Badollini" or "Bodollini" in the same place. It's Perazzi's #100 pattern in their catalog, and it's nice work.

If I'm not mistaken, Perazzi uses nothing but hand engraving. I think I recall Ray Stafford telling me that the only difference between an MX2000 and an MX10 was about $1,000 worth of engraving. I've had an MX2000 and an MX2005 before this one, and I'm pretty sure they were both hand engraved.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top