Trapshooters Forum banner

Paterning board grease

2475 Views 10 Replies 11 Participants Last post by  dead on 4
Need to know what to use for grease on a steal patterning board.

Luke Kalina
Status
Not open for further replies.
1 - 11 of 11 Posts

· Registered
Joined
·
221 Posts
Luke, I have had one for a couple years. Any grease will work but I prefer a colored grease like blue or red if available and is rather cheap. I use a 6" foam roller and just be sure to re-roll it after your last shot to help prevent rust. Another thing I found is not to put too much on. It makes seeing results more difficult. I also put a hole in the center with a bolt through it and then I hook a 15" string and a stick or pencil to draw my 30" circle in the grease. Just keep it thin and have fun. Lee
 

· Registered
Joined
·
15,172 Posts
Sand and dust will make it brown in short order if your splatter board is outside 24/7.

Buy the cheapest grease you can find.

I hang a cheap grease gun on the side and use a paint roller to spread it after each shot.
 

· Registered
Joined
·
8,427 Posts
The local Ikes club uses paint and the rest of the clubs I belong to uses grease....grease is the only way to go.....faster to spread and each shot is like on a new board where paint is dimpled and gets thick until you scrape it off.
 
1 - 11 of 11 Posts
Status
Not open for further replies.
Top