Trapshooters Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
i picked up a dl-155 in a deal and it has no powder or shot bushing in it and it is marked on it 20ga. with a sticker on the tubes can anyone tell me what i need and where i can get these,?? or tell me what size they are my son has a a lathe and if i talk nice he might make them for me. thanks for any help i can get,,
 

·
Registered
Joined
·
183 Posts
Same bushings as their 366.
They used the same Hornady bushings in the 105,155,366.

Sent from my SM-G930V using Tapatalk
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #4 ·
i see they make a bushing so i can use my mec bushings have you seen these and know where i could get one i can not find it ???
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #5 ·
Same bushings as their 366.
They used the same Hornady bushings in the 105,155,366.

Sent from my SM-G930V using Tapatalk
i see they make a bushing so i can use my mec bushings have you seen these and know where i could get one i can not find it ???
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #8 ·
thanks again to everyone for the info got everything ordered and printed out , i should be up and loading soon,
 

·
Registered
Joined
·
136 Posts
Hornady, Spolar, Ponsness, Bair, RCBS, all use the same bushings. Some are steel, some are aluminum. Ebay has them for 4-6 bucks all day long. Can;t remember the dimensions, 3/4 X 1 inch for powder? 7/8 X 1 for shot? Some use decimal system for sizes, some use lettering system,
 
1 - 9 of 9 Posts
Top