Trapshooters Forum banner
1 - 3 of 3 Posts

·
Vendor
Joined
·
20,112 Posts
Discussion Starter · #1 ·
Late issue, 116,000. Absolutely NEUTRAL. In perfect visual condition. But installed on a gun it will show a minute lower tang crack. Easily neutralized by a little thinning of the abutted area and it will never show or cause an issue. This stock will fit a RS or a 2005 or a MX10 top single bbl. $500 shipped. I might be able to match a forend to it as well.
Wood Hardwood Wood stain Plywood
Wood Cutting board Tool Plywood
Floor Table Wood Flooring Hardwood
Table Floor Wood Furniture Flooring
 

·
Vendor
Joined
·
20,112 Posts
Discussion Starter · #2 ·
Once on your receiver the tiny crack/imperfection*may show up. Then it is simple to do a touch of dremel to the tight area and the crack will again disappear. NOte that the stock is the same from port or starboard side. It begs for a lefty.

* May not appear when on YOUR receiver.
 

·
Registered
Joined
·
199 Posts
Late issue, 116,000. Absolutely NEUTRAL. In perfect visual condition. But installed on a gun it will show a minute lower tang crack. Easily neutralized by a little thinning of the abutted area and it will never show or cause an issue. This stock will fit a RS or a 2005 or a MX10 top single bbl. $500 shipped. I might be able to match a forend to it as well. View attachment 1663389 View attachment 1663391 View attachment 1663393 View attachment 1663395
Hi Jack spoke with you the other day. I had the db81 O/U barrel with perazzi removablem choke tube in the bottom barrel. Bore was 18.5, found some Teague choke tubes for it. So with the higher rib your db81 stock you have listed will it fit a Perazzi mx2000 receiver. I may need it for my gun. Let me know what you think. Thanks Frank
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top