Trapshooters Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Anyone have a low pressure one once load (8000 PSI or lower) using 12 gage Federal papers, Green Dot, and Winchester primers? Need this data for loads in a 1894 SXS H&H shotgun. Thanks for your help. Jesse in Lincoln, CA
 

·
Registered
Joined
·
500 Posts
I am using 20.6 grains of Green Dot and a Downrange clone wad for 1 1/8 once loads I do not remember what the speed was when I checked it last year, but that is my singles load that I have used for over three years.

Jim Bradbury
 

·
Registered
Joined
·
2,567 Posts
Alliant often only list primers that match the hull.

The are couple of 1 oz loads listed in their 2013 Reloaders' Guide that is below 8,000 using Fed 209A primer.

Fed 209A, wad CB 6100-12, 20.5 Gr GD, 6850 psi 1200 f/s.

bump it up to 22.0 gr GD, 7240 psi 1250 f/s.

There is a 1 1/8 oz load: Fed 209A, wad 12S3, 18.5 gr GD, 7400 psi 1145 f/s.

21.0 gr GD, 7800 psi 1200 f/s.

If you plan to use these loads, please confirm with the on-line guide.

Jason
 
1 - 4 of 4 Posts
Top