Trapshooters Forum banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Registered
Joined
·
94 Posts
Discussion Starter #1
I have a shotgun that came with the manufactures stick on logo on the barrel. How do I remove it without damage the blueing? Thanks for any help... gene
 

·
Registered
Joined
·
3,476 Posts
Spray with WD40 and let it soak. Or you could use a hair dryer to soften the adheasive then pull the sticker off.


Eric
 
E

·
Guest
Joined
·
0 Posts
The WD 40 is very good at removing adhesive residue from about any surface. Mixer has it rigt.

ec90t
 

·
Registered
Joined
·
27 Posts
"Goof Off" available at stores everywhere. Made for removing stickers and such without damaging the substrate (so long as its not plastic).
 

·
Registered
Joined
·
9,529 Posts
Wait for a nice hot day next summer. Sign up with a fast shooting doubles squad. After the event, just peel the sticker off without burning your fingers.

Pat Ireland
 

·
Registered
Joined
·
5,691 Posts
Just had a can of Goof-Off sitting here, so I tried it on a little metal part that was blued and it didn't harm the bluing. Sure stunk up the room though,
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top