Trapshooters Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
I am rebuilding a much neglected model 12 Winchester 12 Ga.shotgun.

The only problem part seems to be the action slide (part #1 inthe Numrich Arms schematic), The action slide is detached from the sheet metal extention tube that the forend nut attaches to.

There are 8 holes which seem to be a form of blind rivet upsetting materal from the machined part of the slide into the sheet metal extention. The two peices are no longer joined.

My question is how do I repair this unit?

Bill
 

·
Registered
Joined
·
1,738 Posts
My suggestion is to get another gun or gunsmith to provide you with correct info. Some of us have not worked on these guns as much as we did. Just fixed a slide action bar the other day. It needed welding.If you are ever in Ontario,Canada I will disassemble my grandfathers gun and we will both check it out. Wright's,Illinois could likely repair it.


Joe Woods/Ontario
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top