Trapshooters Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
3,194 Posts
Discussion Starter #1
looking to have a mid bead installed in a browning barrel, who would you send your barrel too ? thanks for any replies
 

·
Registered
Joined
·
54 Posts
Depending on the gun I would definitely give this go. I love Larry Potterfields Midway USA gunsmithing videos.
 

·
Registered
Joined
·
3 Posts
This is a straightforward job for any competent local gunsmith. I've seen them installed by a couple of different local gun plumbers and the results were satisfactory. Shouldn't require the additional effort/expense of sending to a specialist, unless you want to....
 

·
Registered
Joined
·
3,194 Posts
Discussion Starter #6
the gun is a Browning CXT the mid bead hole was drilled off center from the factory and with the adjustable comb the beads could not be lined up, so i took the mid bead out and been shooting the gun like that for over a year, didn't wanna send it back to browning because i dont have a back up gun, was just a thought of having a mid bead installed and wanted it done correctly
 

·
Registered
Joined
·
66 Posts
the gun is a Browning CXT the mid bead hole was drilled off center from the factory and with the adjustable comb the beads could not be lined up, so i took the mid bead out and been shooting the gun like that for over a year, didn't wanna send it back to browning because i dont have a back up gun, was just a thought of having a mid bead installed and wanted it done correctly
I could rent you my BT 99 while yours is in the shop .Price would be 1 Denics pork sandwich
 
1 - 10 of 10 Posts
Top