Trapshooters Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1
I have a MEC 9000h. The problem is when I press the petal at station 1 the loader progresses before the shell will clear the collet. This binds the loader. Do any of the Mec loader experts have any ideas?

Thanks in advance,

Bob Collins
 

·
Registered
Joined
·
595 Posts
adjust the nut on the down rod that controls the release of the shell plate, if its releasing to soon you need to lower it a turn or two, same rod that the wad guide fingers are on and the fork that lowers the shell into the collet.


Good luck,


Rick
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top