Trapshooters Forum banner

1 - 16 of 16 Posts

·
Registered
Joined
·
1,091 Posts
Discussion Starter #1
Is there some way to tighten that up. One tube is tight and one is usable but not fitting tight.
 

·
Registered
Joined
·
2,450 Posts
  • Like
Reactions: Big Az Al

·
Registered
Joined
·
1,779 Posts
Depends what kind. Briley Sidekicks have have a red or white nylon tab on the side to you can swap out for a new one to tighten it up.
 

·
Registered
Joined
·
1,002 Posts
Take the tube to a machine shop along with the barrel and have the tube knruled to fit the barrel.It is a couple minute job.
 

·
Registered
Joined
·
421 Posts
Briley machines a dovetail for a polymer insert which is held in place with "super glue" so a new insert can be installed if the tube becomes loose again.
 

·
Registered
Joined
·
421 Posts
A friend used strips of paper from his document shredder.

IMG_0609.jpg
I was told Briley would do this to Kolar tubes as well.
 

·
Registered
Joined
·
3,754 Posts
A friend used strips of paper from his document shredder.

View attachment 1682507
I was told Briley would do this to Kolar tubes as well.
I'm not sure what decade that story might be from....but Kolar actually started the trend of putting Teflon "Chamber Buttons" on the outside of the chamber on their tubes, and later Briley started doing the same thing.
 
1 - 16 of 16 Posts
Top