Trapshooters Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
1,003 Posts
Discussion Starter #1
I have inherited a Lefever receiver and stock (I do not know where the barrel is). The receiver is of a 12-gauge single-barrel break-open type and the serial number is 3246. The stock is broken and may not be repairable. On either side of the receiver is engraved a duck in flight and the words “LEFEVER ARMS CO ITHACA NY”. There is surface rust but the action inside is relatively clean and works perfectly. My question is, should I bother cleaning the outside of the receiver? Is there a best way? Anyone have an orphan barrel or stock/forend that might fit this receiver? Thanks for any advice.

LA in MA
 

·
Premium Member
Joined
·
3,907 Posts
Porcupine, Try the guys on doublegunshop.com go to the forum you will find your way threw it. I think your out of luck all that stuff was hand fit and parts like barrels and forarms don't just fit. Also very hard to find parts. JMHO, Bill
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top