Trapshooters Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
16,756 Posts
Seems to me like there is a little pin to drive out that holds it. Johnnie Boy had one, never changed it.


HM
 

·
Registered
Joined
·
165 Posts
Place the barrle rib on a small piece of wood for suport and drive to the two pins that hole the hanger in place out then slide the hanger the rear and take the little key out that keep the hanger straight be careful not to lose it it very small then lift the rib up just a little to let the hanger to slide off the barrle clean the out side of the barrle with a rag to get all the drit off to install the new one just reverse also plcae a little gearse inside of the new hanger befor sliding it back in place and don't forget to put the key back in place slide it foward to lock the key in place and drive the to pins back in place and you all set
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top