Trapshooters Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
945 Posts
Discussion Starter #1
Ottsville his best bet , to complicated to give you an answer with out seeing it ! B.C.
 

·
Registered
Joined
·
9,529 Posts
I would first check the small set screw that holds the trigger tight. It is on the left side of the trigger looking from eithor the barrel end or the stock end.

Pat Ireland
 

·
Registered
Joined
·
1,612 Posts
sts100.

There are two set screws on front side of trigger. The back one is used to adjust length in trigger pull, and the front one is to lock the barrel selector.The back one should be tight, but the front should be slightly loose if you want to use the barrel selector, which is in front of trigger.

David McMillen
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top