[brdslayr]

What is the procedure to remove the bolt assembly from a Winchester SX1? Thanks JW

 

[Oregunner]

Remove the trigger assembly. Disconnect the recoil spring linkage, and pull the bolt back in the receiver. It comes out through the bottom of the receiver. click on link above. Mark

 

[BigM-Perazzi]

When you've reached your futility level, it will fall out.

 

[wayneo]

Hold up on the bolt linkage while you depress the return spring follower, that way it wont fall down.

Now is a good time to pull the stock and replace the buffer if it been a while since its been replaced.

Wayne

 

[Oregunner]

My pinkie fits inside the bolt link follower, and I pull it up and out, while I depress the return spring follower with a medium blade screwdriver. Once the follower is clear of the receiver, I slide the bolt to the back, turn the receiver upright and wiggle the bolt back and forth until the bolt falls out. The first time removing it is the hardest. As you do it more, it seems easy. Mark

 

[trench12]

please continue as how to disassemble the bolt.

 

[Bob Hawkes]

trench, when I needed that I sent the bolt to Stu Wright for repair.

 

[wayneo]

Trench.... here ya go, travel at your own risk. Disassembly is #25 to #30. Reassembly tips are,#1 and #2.

Wayne

 

[wayneo]

Good point Repete

Wayne

 

[Oregunner]

Pull the cocking lever out of the bolt. It will come out of the receiver easier, if you do this. Mark

 

[trench12]

thanx for the info!!!!! tg