Trapshooters Forum banner

Help with Perazzi release trigger

630 Views 4 Replies 4 Participants Last post by  DC Claygunner
I just broke a spring for the bottom barrel. Replaced the spring and now it will not hold very good. As I'm going to the target, it just goes off. Also feels harder to set. Even with the trigger out of the gun, just setting here holding the trigger, it really doesn't seem like I'm letting pressure off and it will release. I didn't replace the other spring. Thanks for the help.
1 - 5 of 5 Posts

· Registered
Joined
·
2,617 Posts
Trap2012 gave you the answer. In that same vein is the sear spring plunger - did you retain the spring but launch the plunger ??
 

· Registered
Joined
·
140 Posts
Discussion Starter · #5 ·
Thanks for the help. I went in tonight and there is no plunger with the spring. So I carefully removed the other side (top barrel). There is no plunger on that side either. Never had that side apart from when the trigger was converted to release.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top