Trapshooters Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
11,025 Posts
Discussion Starter #1
Depending on the trigger, you can have up to 3 adjustment screws. One of them is spring loaded. That is the one you want to adjust. The weight of pull screw is located on the front of the trigger assembly. It should have a small lock nut. Loosen the lock nut and turn the screw clockwise to increase the weight of pull. Then tighten the lock nut. You might have to change the spring to a stronger spring to get the weight up to 2 lbs.

The other two adjustment screws are for sear engagement and over travel. HMB
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top