Trapshooters Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
109 Posts
Discussion Starter #1
I just got this 375 pw reloader and so far i don't like it.i ran a shell threw it at the final crimp it makes a hole in the top of the shell. and if i get one to half ass work then when i go to knock it out it puts a big hole in the top and all the bb come out what am i doing wrong. any one else ever had this problem
 

·
Supporting Vendor
Joined
·
5,490 Posts
If you are going to load a steel base hull on a P/W loader you need to size the hull with a MEC collet sizer otherwise the hull will be difficult to insert and remove from the P/W shell holder. The P/W shell holders are designed to reload only brass headed hulls.

The tight fit of the hull in the shell holder causes the knock-out punch to deform the shell when it is pushed out.

Jim Skeel<br>P/W Dealer/Distributor
 
1 - 4 of 4 Posts
Top