Trapshooters Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
129 Posts
Discussion Starter #1
My club is looking to buy and install automatic traps but our trap houses are close to to height size .Iwas wondering if when you measure the trap house do you measure the back side of the house or the front side .I think it's 36 inches from ground to roof any info welcomed Thanks Rick
 

·
Registered
Joined
·
2,829 Posts
Here is the ATA rule(s) ... Bill Malcolm

Traphouses must adequately protect the trap loaders and shall not
be higher than necessary for that purpose. It is recommended that
traphouses constructed after September 1, 2003 shall conform to the
following specifications:
1. Length not less than 7 feet, 6 inches, nor more than 9 feet, 6
inches.
2. Width not less than 7 feet, 6 inches, nor more than 9 feet, 6 inches.
3. Height not less than 2 feet, 2 inches, nor more than 3 feet, 0 inches,
the height to be measured from the plane of the number 3 shooting
position.
It is recommended that the throwing surface (throwing arm or plate) of
the trap machine be on the same level as that of Post 3 and the target
height setting pad.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top