Trapshooters Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
158 Posts
I have a set of drawings that I made, But if you don't have autocad program you will not be able to open them. I got the design from the Kansas trap Assoc. website about a year ago. then refined the rough drawings in acad.
I may be able to tranfer them to a word doc. Lou
 

·
Registered
Joined
·
839 Posts
We had a volunteer make a rack. He was a skeet shooter and put the insets(right word?) opposite each other. Works for skeet guns, but not of 32/34 trap barrels. The insets should alternate or the top piece should be wider.
This only applies on double sided racks.
Bill
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top