Trapshooters Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
2,476 Posts
Discussion Starter · #1 ·
I'm working on an old Stevens 5000 SxS and need a new sight bead. Normally I'd just have it replaced with a more modern sight, but this one is drilled into the rib about a 1/4 of the diameter of the bead. If I just drill it out it would leave a significant depression in the rib, anybody know a place to get a replacement for just the white bead that I could glue back in? I tried the sewing pin method that someone else suggested but I'm having a difficult time finding the correct size. It looks like a 0.15 or 0.14 would fit correctly.


Thanks,
Mike
 

·
Registered
Joined
·
2,476 Posts
Discussion Starter · #3 ·
I tried both, Midway and Brownell"s, plenty of sights but no plain beads to repair a sight?

Mike
 

·
Registered
Joined
·
2,476 Posts
Discussion Starter · #4 ·
Found out it was a pressed in bead and ordered a new one from Brownell's.

Mike
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top