Trapshooters Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
I have a 16ga Hunter Arms Fulton with 26" barrels choked IC/M that I'd like to trade.

I bought the gun based only on pictures, and the LOP ended up being a little short for me at just a hair shy of 14". Even though it doesn't exactly fit me, I took it out for a successful afternoon hunt earlier this fall so I do know that it's 100% functional.


C0242D0F-3440-427D-A8CA-E6849CDEEAEF-427-0000002EF4938589_zps42467205.jpg



Here are the original pictures from the seller; I can take more if you'd like:


Fulton1_zps535cf099.jpg




Fulton3_zps34cb2926.jpg




Fulton2_zpsfa693159.jpg




Fulton4_zpsde028e9f.jpg




Fulton6_zps6ef2912a.jpg




Fulton5_zps9b543e03.jpg



Also, here are a couple points to be aware of that might not be immediately apparent in the pictures:

- The recoil pad is slightly proud of the stock, just enough that there's a slight ridge at the transition between wood and pad.

- On the left side of the barrels there's a worn spot in the finish right in front of the foreend. I would guess that the gun sat in a pickup gun rack uncased.

- The stock has been refinished, and so the screws in the floorplate of the action and on the trigger guard have been turned.

- There are small marks and patina consistent with age, including one old mark in the right side of the grip that's about 3/4" long.

- This gun was sold to me as a 2 1/2" gun. I do not have a way to verify that measure and there are no chamber length markings on the barrel flats, but I will assume it is correct.

Also, I should add that I have not personally verified the choke constrictions, but the seem about correct based on a visual of the ends of the barrels and the patterns they've thrown at birds.

Here are the stock measurements:

DAC: 1 5/8"
DAH: 2 1/2"

LOP, front trigger: 14" or 13 15/16", depending on how I hold the tape.
LOP, rear trigger: 13 1/4"

Cast: Neutral

Weight: 6lb 13oz

The length measurements were taken with a tape measure, and drop was measured by turning the gun over on my desk and measuring from the comb and the heel to the desk. The weight was measured with my digital kitchen scale. Please expect some small error inherent in these methods, but I think they're pretty close.

If you're looking for a solid 16ga shooter, this gun might be the ticket. Please feel free to ask any questions or request any specific pictures you'd like to see.

I'd like to trade the gun for something else in 16, 20 or 28ga. Also, I would be willing to swap for a DSLR camera setup, a medium caliber deer rifle (i.e. not a .243, and not a big magnum), a 3 or 4 wt fly rod and reel, or some other nice piece of outdoor gear.
 
1 - 7 of 7 Posts
Top